Reply to Thread

Post a reply to the thread: timing guides tip, no head removal

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.


Additional Options

Topic Review (Newest First)

  • 11-26-2008, 02:48 AM


    10k on motor since, no issues
  • 05-11-2008, 09:57 PM

    I was using a 3/4 inpact gun, havent reassbl. yet

  • 05-11-2008, 01:49 PM

    if it came right off... it was not tight enough.

    how did you get the nut back on>? did you use a torque wrench? with a multiplier?
  • 05-11-2008, 11:20 AM

    i condered that route also

    I was decided I would try tapping it on instead, I didnt feel comfortable with the overlap issue, how many miles ago did you do that? the tapping really did not feel abusive the the parts at all, just that sense of making it happen that is required so often working on cars....
  • 05-11-2008, 11:16 AM

    yes, but slightly evolved...

    you gave me the idea to cut it off, but I cut towards the middle of the shaft to aviod any head gasket issue, and instead of pulling the pin, I left it in and just tapped on the nea tensioner. my logic was this would have no possible damage to the block, only the pin and tensioner were being in play. it worked great.
    thanks for your write up as it helped give me confidence.
    by the way, I removed the rad, and condensor, inorder to use an impact gun on the crankhub nut...came rightoff. also thanks for the heads up on the orings inside the guide, they were not disturbed useing my method.
  • 05-11-2008, 10:31 AM

    I cut mine a little also to get it on..

    be carful the 2 tensionner rails need to over lap each other, dont cut too much
  • 05-08-2008, 06:49 PM

    Re: timing guides tip, no head removal

    You mean like this:
  • 05-06-2008, 11:09 PM

    timing guides tip, no head removal

    hey folks,
    as you may know the lower guide doesnt come out, or go in because of clearance with the head casing. solution...
    to get it out just cut it in half with a cutting wheel, and to put new one on, tuck the upper tip under the headcase, and mate up to the pin, at about 11 oclock. it will be slitly crocked but you will be able to start the pin in the hole easily. dont forget new orings, and to lube the hole. work it on by hand and two medium taps with a hammer and it will pop on. done.

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum