Reply to Thread

Post a reply to the thread: How to remove Harmonic Bal. from around guibo?

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.


Additional Options

Topic Review (Newest First)

  • 03-29-2009, 10:31 AM

    Re: How to remove Harmonic Bal. from around guibo?

    Unbolt the cat from the bracket at the back of the trans. pry off the 3 doughnuts holding the cat back up. That is as far as you need to go with exhaust to remove the driveshaft.
  • 03-27-2009, 10:13 PM

    pry the driveshaft out of the guibo

  • 03-25-2009, 05:55 PM
    steve 86 528e


  • 03-25-2009, 05:45 PM

    Have you dropped the center bearing too?

  • 03-25-2009, 12:33 PM

    How to remove Harmonic Bal. from around guibo?

    I want to ditch my harmonic balancer metal ring from around the guibo.

    I went to drop the drive shaft and found I can't separate it enough near the center support bearing without dropping the exhaust out of the way.

    Went to drop the exhaust and have a frozen nut on the manifold end of it.

    So, I'm looking for a shortcut to getting that Harm. Bal. metal ring off.

    Was thinking leave guibo and driveshaft in place and attempt sawzall o the ring...but am not sure that would work.

    Any suggestions?

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum