Reply to Thread

Post a reply to the thread: Error Code P0305

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.

 

Additional Options

Topic Review (Newest First)

  • 09-23-2009, 04:23 PM
    Penguin

    Re: Error Code P0305

    Here's a thread with the number:

    http://bimmer.roadfly.com/bmw/forums/e85/7206613-1.html

    05E-A01

    If you have a good relationship with a dealer, they can probably get BMW to approval replacement of the coils for free. If you don't have a relationship, and bounce from dealer to dealer to save a few bucks, perhaps not.

    When I was in the industry the costs associated with this were called W&P, Warranty and Policy, The warranty part was what the company was obligated to do, the policy part was what the company did, usually on a case by case basis, to keep loyal customers happy.
  • 09-23-2009, 04:17 PM
    Penguin

    Re: Error Code P0305

    >> Now the question is will the dealer replace the other five for free even after 80K miles?


    Probably, if it meets the conditions in the service bulletin. Ask your dealer to run your VIN in their system to see if it pops up. Mine were replaced without request, as part of the normal check they did when I had the oil changed.
  • 09-23-2009, 02:13 PM
    lool

    Re: Error Code P0305

    I had to have one coil replaced and was not aware of the SIB. So I now have 5 more BREMI coils which could act up at any time. Mine is an early '03 so it falls in the SIB range. Now the question is will the dealer replace the other five for free even after 80K miles?
  • 09-23-2009, 11:05 AM
    Penguin

    Re: Error Code P0305

    OK, after switching the two coils around o help in diagnosing the problem, I have driven more than 500 miles with no code thrown.

    Since a coil is physically small and only about $30, I bought a spare and stuck it in the trunk. If the code returns, I'll swap the new coil in. But otherwise, I'll assume the code was a temporary random misfire issue from sitting around too long between engine starts.
  • 09-09-2009, 06:04 PM
    KenTenn

    Apparently I forgot how to post...

    This was just posted on another forum. Maybe it will help.


    The issue was with the Bremi coils, which may have not made it into the Z4M series. I have read on this forum, regarding a Z4, with a hesitation and new(er) coil packs being installed by the dealer, although it did not resolve the problem.

    Here is the old SIB:

    This Service Information bulletin supersedes S.I. B12 08 03 dated November 2003.
    designates changes to this revision
    SUBJECT
    Bremi Ignition Coil Replacement
    MODEL
    E36/7; M roadster/coupe with S54 from 02/01 up to 06/02
    E46, M3 with S54 from 03/01 up to 11/02, and from 01/03 up to 07/03
    E46 with M54 from 09/02 up to 11/02, and from 01/03 up to 07/03
    E39 with M54 from 09/02 up to 11/02, and from 01/03 up to 07/03
    E53, X5 3.0 from 09/02 up to 11/02, and from 01/03 up to 07/03
    E85, Z4 from series introduction up to 11/02, and from 01/03 up to 07/03
    SITUATION
    Engine may run rough and "Check Engine" light is illuminated. Misfire faults are stored in DME control module.
    CAUSE
    Reduced ignition firing power of BREMI coils due to coil internal insulation deterioration.
    CORRECTION
    Follow the appropriate Test Plan from DIS Plus/GT1.
    If BREMI ignition coil is found to be defective, and the production date stamped on top of other coils housing's is
    42/2002 or earlier, or in the range from 01/03 up to 24/03 all six coils must be replaced . For replacement instructions
    refer to RA 12 13 511 found in BMW TIS.
    Only coils manufactured by BREMI are affected. BREMI coils are easily recognizable by the all black, shiny housings.
    Bosch coils, which can also be fitted in M roadster/coupe and M3 vehicles with S54 engines, are not affected and should
    NOT be replaced as a set. Bosch coils have a silver, aluminum housing.
    SI B 12 08 03
    Engine Electrical
    February 2004
    Service Engineering
    The last four digits stamped on the top of
    BREMI ignition coil housing indicate
    the calendar week and year of
    production.
    As shown on illustration: Week 42 of
    2002
    PARTS INFORMATION
    WARRANTY INFORMATION
    Covered under the terms of the BMW New Vehicle Limited Warranty.
    Note:The following explanations will spell out the correct use of the work times.
    Part Number Description Quantity
    12 13 1 712 223 BREMI ignition coil Maximum of 6
    Defect Code 12 13 91 12 00
    Labor Operation: Labor Allowance:
    Main Work 00 54 124 11 FRU E46, M3 with S54
    8 FRU E36/7, M roadster/coupe with S54
    7 FRU E85, Z4 with M54
    9 FRU E39 with M54
    7 FRU E46 with M54
    7 FRU E53 X5 with M54
    + Associated Work 00 54 692 9 FRU E46, M3 with S54
    6 FRU E36/7, M roadster/coupe with S54
    6 FRU E85 with M54
    6 FRU E39 with M54
    7 FRU E46 with M54
    5 FRU E53 X5 with M54
    Main Work: Use this labor operation number when the only repair performed is the
    listed warranty repair.
    OR
    +Associated
    Work:
    Use this labor operation number when other repairs or services are
    performed along with the listed warranty repair.
    Under no circumstances should both labor operation numbers be claimed.
    Attempts to claim both times will result in an unnecessary delay in claim
    processing and payment.
    [ Copyright 2004 BMW of North America, LLC ]
  • 09-09-2009, 06:03 PM
    KenTenn

    Re: Error Code P0305

  • 09-09-2009, 04:59 PM
    BSVA

    Re: Error Code P0305

    My Z4 did the same thing a few years back, didn't think I would make it to the dealer. The ignition coils were the problem and once replaced, (under warranty), problem solved. BMW knows too well that there were problems with the coils and should replace them with no questions asked.
  • 09-08-2009, 05:41 PM
    Penguin

    Re: Error Code P0305

    I'm in the midst of solving one right now. I got a P0306 code. I figure it is most likely the ignition coil, considering BMW already has had one recall to replace the coils on some of the Z4's.

    My first step has been to switch the cylinder 6 and cylinder 5 coils and reset the code. So far the code has not come back, but if it comes back as a P0305 (cylinder 5), then I know it is almost certainly the coil causing the problem.

    Note that since the Z4 engine uses a "coil above the plug" system, it is extremely unlikely that the plug wires are the problem -- the wires no longer carry high voltage, as in the older style systems, and rarely fail or deteriorate.

    Now, on a BMW there is another likely reason you can easily check. Often the valve cover gasket can develop a leak, and sometimes it will result in the spark plug cavity filling with oil, causing a misfire. This is rather easy to check, as if the spark plug cavity is filled with oil, that's the problem.
  • 09-08-2009, 04:08 PM
    scottolsen

    Re: Error Code P0305

    It's a misfire in cylinder No. 5.

    Your car has no wires or boots.

    My guess (and I bet I'm 99% right) is it's the coil for that cylinder.
  • 09-08-2009, 12:47 PM
    El_Z3

    Error Code P0305

    Okay, after about 2 months of not driving my Z4 because it started to spunder/rough idle, I took it out this holiday weekend to check out, and the code I got back was P0305, here is what I found on the net:


    It seems to say that there are generally 4 possibilities in case of a P0305 (or any P030x) cylinder misfire:

    1. - sparkplugs
    2. - plug wires/boots
    3. - ignition coil
    4. - fuel injector


    Now, from reading from other forums, #1 it seems this is very common, #2 it a game of trail and error finding out what could be the cause, spark, wires, coils etc... I am just wondering if anyone else had this problem before and how did you fix it?

    Thanks

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum