Reply to Thread

Post a reply to the thread: Speedometer circuit board diagram needed

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.


Additional Options

Topic Review (Newest First)

  • 04-14-2010, 03:25 PM

    Re: Speedometer circuit board diagram needed

    Just in case you still need this (and an E30 gauge view helps you), I had my '85 325e speedo opened up last week to change SI board batteries and found that the a resistor had been burned also. My resistor was a 33-ohm.

    [email protected]: (component side view) (solder side view)
    <IMG SRC=><FONT FACE="Comic Sans MS" COLOR=Gray SIZE=+1>PaulR</FONT>
    <FONT COLOR=Black>'CCA Memb #8743
    '99 M-Coupe - Silver/Black
    '85 325e - my "Ol' Paint"
    '96 VFR750F - smooooth
    '86 Ducati 750-F1 - raw, obnoxious</FONT>
  • 10-03-2009, 01:28 PM

    that IC chip pdf

    has an exemplary circuit with component values that is almost exactly what VDO designed.

    Don't understand why you still have MPG... that relies on the electronic output from the chip that the pdf also shows.

    FWIW, my iX speedo was intermittent, but was two reasons: the pulse sender in the diff, and a bad solder joint on the integrating capacitor.

    A burned resistor is usually an effect of a problem, not the cause.
  • 09-29-2009, 09:01 PM

    Is that resistor on the main board or just on the

    small speedo oard?
  • 09-29-2009, 08:49 PM

    Do you mean the one on pin 7 of the C1 blue plug?

    Is that the supply you're tracing? My car is earlier and a Euro. Sorry.
  • 09-29-2009, 02:07 PM
    Rick Z

    Speedometer circuit board diagram needed

    Hi all. Does anybody know anything about the speedometer circuit board from an '85 535i? My speedo and odo stopped working after a long layoff for engine work - tach and mpg gauge work fine and diff sensor checks OK. I've taken the instrument cluster apart and the speedo board off the back of the gauge - there is a resistor that has burned black and I suspect it is the cause of the problem. It comes from the +12 supply. I happened to find on another BMW forum (e30) someone who had the pdf info on the IC chip (it's a UAF2115 that is commonly used for speedos and tachs). The problem is that I can't tell what value the burnt resistor is so I need a schematic diagram of the circuit. The part number on the board is 92 644 696 (it might be 992 644 696). Any ideas? Thanks.
    Rick Z

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum