Reply to Thread

Post a reply to the thread: key ignition wont turn to start position

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.

 

Additional Options

HTML

Topic Review (Newest First)

  • 02-09-2010, 01:59 PM
    MezzyMarv

    which wire????????

  • 02-03-2010, 09:55 AM
    MezzyMarv

    Re: key ignition wont turn to start position

    It's a 1973 2002. I've checked the starter connection and seems fine. I will check the key ignition itself in a few days when I'm off. My last result will be to install a push button to start the engine while still using the key by turning on the power. I just need to know which wire that I should connect to the push button switch from the back of key ignition?
  • 02-03-2010, 12:51 AM
    ClydeG

    Re: key ignition wont turn to start position

    It would help if you had stated the year model of your there are two (blade type) screws on the back of the ignition switch to which attach about 10 wires (look for disconnected wires). Try to tighten the screws (just in case they have somehow backed out). If they are tight (righty tighty, lefty loosey - or clockwise to tighten, counterclockwise to remove) , disconnect the battery and unscrew the them and carefully pull that part back and turn the key in the ignition to see if it rotates into the start position to check the ignition component that the key pins control (locks the steering shaft, etc). If it rotates as it should then that problem is probably eliminated. Next, insert a screwdriver into the electrical switch component of the ignition that you detached and carefully rotate it clockwise to check it. If it rotates and springs back, you can reconnect the battery and carefully (avoid shorting the switch or wires to ground unless you really are masochistic) Some keys are longer than others to better engage the electrical component. About the only other possible problem is that the wire from the ignition switch has become disconnected from the starter (on most 2002s, there are 2 male plugs on the solenoid attached to the battery - and only one of them energizes the solenoid and starter).
  • 02-02-2010, 03:43 AM
    MezzyMarv

    key ignition wont turn to start position

    therefore, the car won't start because of this. Either I replace the key ignition or maybe install some type of a push button switch to bypass the key ignition. Will this work? which wires do I connect to the push button switch? or can I run directly from the starter?

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum