Reply to Thread

Post a reply to the thread: Valve Cover Gaskets - Here I go Again...

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.

 

Additional Options

HTML

Topic Review (Newest First)

  • 11-19-2010, 04:43 PM
    jimlev

    I have 70K on my VC gaskets too, no leaks (m)

    I used Permatex high temp RTV silicon (6B or 26B red or blue), a very small amount on the head side of the gaskets, a bit more in the corners next to the 1/2 moons in the back.
    I always use a little sealant and never had a problem. I always make sure the head and gasket surfaces are free from oil, clean with alcohol before I apply the RTV.
    I supplied Rajaie with some 540 info too.
  • 11-19-2010, 03:02 PM
    Philly98540i6

    Valve Cover Gaskets - Here I go Again...

    Hi All,
    Car is now 12 years old with 115K miles, (8 cyl car). I did the VCG job about 7 or 8 years ago (approx 70K miles ago), and they are starting to slowly leak again and cause the stinky burning oil smell as the drop of oil hits the hot exhaust header near the rear of the head. Not loosing much oil at all, but it does cause the annoying smell sometimes.

    Last time, I did the total strip down and repaint of the covers (I did not paint in the gasket groove). I used an additional sealant (permatex rubber gasket prep) on all gaskets and bolt donuts. The repair worked for a good long time, but needs a redo now.

    I followed some of the great tips on this site. They are unbelievably helpful!!!

    Questions:
    Anyone have longer VCG life than this example on a daily driver?

    Anyone try Silicone (RTV) or some other additional sealant with good success?

    I am really trying to pin down what works best to get the longest lasting repair.

    Use a sealant? Don't use a sealant? What type of sealant? etc.


    Related to topic: Anyone try to invent a small sheetmetal shield to stop the very small drip at the back of the head from dripping directly on the hot header?

    Car still runs excellent, but is due for some suspension work soon and these VCG's. Suspension is 100% original except for the thrust bushings I replaced (Rajaie used some of my input on his write up on that procedure)

    Thanks for any and all comments. Much appreciated.

    Chris

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum