Reply to Thread

Post a reply to the thread: Hylomar or not ????

Your Message

Click here to log in

Please correctly re-type the phrase f o o t d o c t o r in the form box. Re-type it without the extra spaces and put the one space where it should be. We apologize for having to do this but this silliness helps slow the spammers.

 

Additional Options

HTML

Topic Review (Newest First)

  • 02-12-2011, 12:54 AM
    Gerry, UKCSi

    Not necessary

    You will not need to use any Hylomar here if you are using new gaskets. I believe it will lubricate the mating surface to allow the gasket to "settle" as it is tightened but then on the other hand, it is keeping the raised ridge of the new gaskets from seating on the heads.
    I would use a thin smear of grease on the cam cover gaskets to allow settling rather than Hylomar unless the face is scored.
    I really dont like hylomar with rubber gaskets but its fine with cork and paper gaskets.
  • 02-11-2011, 07:59 PM
    adciocca

    Re: Hylomar or not ????

    I used it. It's sticky and makes a better seal. Be extra careful with the gaskets in the rear of the car where you cannot see. Use a mirror to make sure that the seal is properly seated. Your fingers just won't do.
    Thanks,
    Antonio

    1991 BMW 850i (black-USA)

  • 02-11-2011, 01:25 PM
    smanaces

    Re: Hylomar or not ????

    In my opinion, it will only make a better seal. Ive been using hylomar for a long time, works great!
  • 02-11-2011, 07:58 AM
    Jay '97 M73 70K

    Hylomar or not ????

    Intakes removed and new gaskets purchased [also removed valve covers since they were easy to get to even though they were not leaking] ..... I see alot of past chatter about using Hylomar on the new Intake gaskets AND the new valve cover gaskets,, does that apply to the earlier models only ??? A BMW tech said to reassemble both and not to use anything on either of the new gaskets- intakes or valve covers !!!

    Jay

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum