Re: where isthe A/C slippage sensor relay located pls?
A little difficult to get to.
It is under the drivers floor side. Have to remove the
left speaker cover mat, (after the hood release handle & screw).
On the left lower body side there are several screws holding
a bracket which holds the mount for the relay. You have to
remove the bracket screws, then you can get to remove/exchange the old for new relay (See the electrical manual on Wuffer's site)
There were 2 relays produced, the old one would detect slippage
signals from the old A/C compressor and cut it off until you
shut down and re-started the engine.
The new compressor will not run with the old relay because it
does not send a signal to the relay ... Actually, it does nothing
but tell the new compressor to run, slippage or not. But,
the new compressor has a larger pully and belt, so I guess they
did not need a slippage signal