How to remove Harmonic Bal. from around guibo?
I want to ditch my harmonic balancer metal ring from around the guibo.
I went to drop the drive shaft and found I can't separate it enough near the center support bearing without dropping the exhaust out of the way.
Went to drop the exhaust and have a frozen nut on the manifold end of it.
So, I'm looking for a shortcut to getting that Harm. Bal. metal ring off.
Was thinking leave guibo and driveshaft in place and attempt sawzall o the ring...but am not sure that would work.
Have you dropped the center bearing too?
pry the driveshaft out of the guibo
Re: How to remove Harmonic Bal. from around guibo?
Unbolt the cat from the bracket at the back of the trans. pry off the 3 doughnuts holding the cat back up. That is as far as you need to go with exhaust to remove the driveshaft.