+ Reply to Thread
Results 1 to 5 of 5
  1. #1
    Registered Member
    Location
    Coventry, CT, United States
    Member No: 89859 Smcdermott326 is an unknown quantity at this point Smcdermott326's Avatar
    Join Date
    Oct 2003
    Posts
    70
    Rep Power
    0


    Yes | No

    How to remove Harmonic Bal. from around guibo?

    I want to ditch my harmonic balancer metal ring from around the guibo.

    I went to drop the drive shaft and found I can't separate it enough near the center support bearing without dropping the exhaust out of the way.

    Went to drop the exhaust and have a frozen nut on the manifold end of it.

    So, I'm looking for a shortcut to getting that Harm. Bal. metal ring off.

    Was thinking leave guibo and driveshaft in place and attempt sawzall o the ring...but am not sure that would work.

    Any suggestions?


  2. #2
    Registered Member
    Location
    , ,
    Member No: 58142 ROYinGA is an unknown quantity at this point ROYinGA's Avatar
    Join Date
    Nov 2002
    Posts
    2,633
    Rep Power
    0


    Yes | No

    Have you dropped the center bearing too?


  3. #3
    steve 86 528e
    Guest
    Location
    , ,
    Member No: steve 86 528e's Avatar


    Yes | No

    yes


  4. #4
    SEB
    Guest
    Location
    , ,
    Member No: SEB's Avatar


    Yes | No

    pry the driveshaft out of the guibo


  5. #5
    a
    Guest
    Location
    , ,
    Member No: a's Avatar


    Yes | No

    Re: How to remove Harmonic Bal. from around guibo?

    Unbolt the cat from the bracket at the back of the trans. pry off the 3 doughnuts holding the cat back up. That is as far as you need to go with exhaust to remove the driveshaft.

+ Reply to Thread


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Bookmarks

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum