Results 1 to 3 of 3
Thread: Ignition lock Wire
05-31-2009 06:30 PM #1
Ignition lock Wire
I just finished replacing the ignition lock housing on my 72 tii, that's a whole other thread, an internal mechanical part broke.
Reinstalled used one but I can't figure out where the wire goes that slides in alongside the ignition lock, it's a single 16-18 gauge wire with a female connection on the other end.
Will remember successful posters in my will!
Getting the housing off with a grinder and finally a dremel grinder was a lot of fun!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)