+ Reply to Thread
Results 1 to 10 of 10
Thread: Trunk Lid Switch
12-01-2009 08:37 PM #1
Trunk Lid Switch
Does anyone know the location and part number for an 89, 735i trunk lid switch? Lately I have to open the lid all the way then let it partway down then open all the way, 3 or 4 times before my trunk light goes on. Seems to get worse as time goes by. Used to light immediately then had to open/close a couple of times before the light went on.
12-02-2009 06:27 AM #2
12-02-2009 05:46 PM #3
Shogun Trunk Lid Switch Location
Shogun... If the switch is located near the trunk lock why does it seem the light only goes on after I lift the lid as high as it will go and then raise and lower a few inches 3 or 4 times until it goes on? It almost seems as if the switch has something to do with the hinges because the trunk lid doesn't touch anything once it's raised. Any ideas?
12-03-2009 12:46 AM #4
12-04-2009 05:20 PM #5
12-05-2009 08:36 AM #6
right side of the hook in trunk lid, looks...
which goes into the lock, like no. 2 or 3 in the drawing
http://bmwfans.info/parts/catalog/E32/Sedan/Europe/750iL-M70/LHD/A/1988/november/browse/vehicle_electrical_system/various_switches-2/Shogun E32 Tech Tips: http://twrite.org/shogunnew/topmenu.html
12-07-2009 05:19 PM #7
- Castro Valley, CA, United StatesMember No: 13814
Inner Circle ©156 since: Aug 14, 2003
- Join Date
- Sep 2001
- Rep Power
Here's a photo of the trunk lid switch
I have never needed to repair this switch thus not sure if it pops out or not. Is there a screw right behind the switch to remove the assembly? I didn't think of examining that when I took the photo this morning. But you must be able to push the switch in and out to see which part or wire is loosen.
Patrick C 88 750 159K
12-08-2009 06:44 PM #8
Thanks for the Photo and Drawing. Question:
I don't see any mechanical attachment; neither screw, nut or bolt. I was wondering if the switch just pries out of the lid. I tried prying a bit but didn't want to break anything. I'd like to remove the switch and see what's going on there. I squirted some graphite around the plunger itself. So far it has worked almost every time I lift the lid. Still delayed turning the light on a few times. A few times I pressed the light unit gently with my finger when it was on and the light went off. I pressed the switch unit the same way and the light went off a few times. I think there's a loose wire as Shogun suggested.
12-09-2009 08:14 AM #9
just checked my one
there is a screw holding that switch in place like in Patricks photo. When the screw is out, you can pry the switch out of the lid.
That means your microswitch is missing the screw which is holding it in place. So pull it out, check the wire connections on the back side, if they are o.k., add a screw that holds it in place and the prob is solved.Shogun E32 Tech Tips: http://twrite.org/shogunnew/topmenu.html
12-10-2009 06:40 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)