+ Reply to Thread
Results 1 to 4 of 4
Thread: dreaded heater stuck on cold
-
01-10-2011 12:49 PM #1
dreaded heater stuck on cold
hiya all
i have just bought a late 95 740a,im in the uk.
i have read many many posts on here about the heater issue but mine doesnt seem to be covered.
when i bought the car i never noticed there was no heat out of the heater matrix,heater controls all seem to be fine,temp goes up and down on display but none out of vents,blower speeds up and slows as it should.centre dash vent set on red dot not blue.
i have noticed that theres no blowing on the drivers footwell either.i suspected the heater valve on engine bulkhead.i took it of and connected the electrical wires to it,the pump operates.
i connected it back to the pipes and bled system.
still no change.
reading other posts it only mentions failing in the hot position not the cold.
as the weather has been in the minus for a few weeks i darent drive it for fear of freezing inside the car.
any ideas guys?
cheers
daveowning the dream is a reality
-
-
01-10-2011 07:14 PM #2
-
01-11-2011 02:20 PM #3
-
01-17-2011 05:40 PM #4
The valve assembly has 2 solenoid coils and 2 cone
shaped valve plungers. The signals from the IHKA cause the solenoids to move the plungers up-down to send hot water to each half of the heater core. The valve assembly can be taken apart, carefully. I think there are pictures on the web, probably on e38.org. Do a search there. The valves sometimes get clogged.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks