+ Reply to Thread
Results 1 to 3 of 3
  1. #1
    Tkent02
    Guest
    Location
    , ,
    Member No: Tkent02's Avatar


    Yes | No

    Float level adjustment on a Weber 32/36 DGAV?

    What is the correct procedure? Thanks.


  2. #2
    Creighton D.
    Guest
    Location
    , ,
    Member No: Creighton D.'s Avatar


    Yes | No

    WEBER float level gauge......

    E mail me a request and I'll E you a scanned image of the official WEBER float level tool. Its part number is 88.007.350
    Believe it or not, I found one at a swap meet, and the guy selling it had no idea what it was for, only I saw the WEBER logo imprinted and later read about it's use in one of the many WEBER tuning manuals.
    The 32/36 spec is 40 to 41. It's heavy milled brass and stands on the gasket surface of the carb top , put a 5/32" drill through the hole and it should rest against the bottom of the float. You could use a vernier caliper and a good eye also. ( 40 to 41 mm )I'll also post it to the 0h2 photo gallery.
    Creighton D.
    76 2002 #2743711 (you know, the one with the WURTH black wheels)

  3. #3
    [email protected]
    Guest
    Location
    , ,
    Member No: wr3238@yahoo.com's Avatar
    Reply With Quote Reply With Quote 76.29.253.133

+ Reply to Thread


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Bookmarks

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum