+ Reply to Thread
Results 1 to 6 of 6
  1. #1
    Registered Member
    Location
    , ,
    Member No: 86770 sonoronos is an unknown quantity at this point sonoronos's Avatar
    Join Date
    Sep 2003
    Posts
    31
    Rep Power
    0


    Yes | No

    Tremec/BW T56 adapter plates available for M20?

    Does anyone know if there are any Tremec/Borg Warner T56 shifter adapter plates available for the BMW M20 engine?

    Sincerely,

    Edward


  2. #2
    Kris
    Guest
    Location
    , ,
    Member No: Kris's Avatar


    Yes | No

    Is there a bellhousing for a tremec/bw for a m20?

    That would rule... seriously.. is there

  3. #3
    Registered Member
    Location
    Los Gatos, CA, United States
    Member No: 35234 mwrench is an unknown quantity at this point mwrench's Avatar
    Join Date
    May 2002
    Posts
    1,028
    Rep Power
    0


    Yes | No

    I am making one for the M30/S38

    I didn't consider the M20 but it could be done if I had a bellhousing (as in 265 trans), even if it came from an automatic. Don't know much about the M20 but if enough interest, who knows?

    HTH

  4. #4
    ///ARINUTS...
    Guest
    Location
    , ,
    Member No: ///ARINUTS...'s Avatar


    Yes | No

    WOW!!! Make me one TOO!!!!


  5. #5
    Edward
    Guest
    Location
    , ,
    Member No: Edward's Avatar


    Yes | No

    My thoughts on how to make

    It can be done with a dead bellhousing from an older e30 5-speed tranny found in the junkyard (chopped to length), welded onto an adapter plate for a T56. Wouldn't be cheap, unfortunately, as T56 adapter plates are hella expensive. However, it's a possibility.

    Is there a generic bolt drilling pattern available for the T56?

    Sincerely,
    Edward

  6. #6
    User Level 1
    Location
    , ,
    Member No: 192202 transeurope is an unknown quantity at this point transeurope's Avatar
    Join Date
    May 2012
    Posts
    1
    Rep Power
    0


    Yes | No
    In search for a plate for a m70 in combination with auto bellhousing. Thanx in advance! Or has anyone an idea how many cm/inch I have to mill the belhousing and how tick the plate has to be? I"m using TTV racing s62 7.25 flywheel and probably tilton ot2 clutch
    Reply With Quote Reply With Quote 84.195.119.23

+ Reply to Thread


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum