+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    ///ARINUTS...
    Guest
    Location
    , ,
    Member No: ///ARINUTS...'s Avatar


    Yes | No

    M20 Oil Feed line SIZE

    Situation: using oil presure sender / switch location on block to feed turbo. I made a "T" fitting, one side will retain the sensor, the other side will be drilled and feed the turbo. What size should that hole be?? What is the smallest the hole can be to feed the turbo sufficiently??? And what is the biggest the hole can be without bleeding off too much oil and drop oil pressure to the rest of the engine?? I do have oil sprayers so already I'm loosing a bit of pressure there. Not too much, but everything should be accounted for.

    So anyway What is the perfect size for that hole???


  2. #2
    Michael McCoy
    Guest
    Location
    , ,
    Member No: Michael McCoy's Avatar


    Yes | No

    Re: M20 Oil Feed line SIZE

    The general recommended sizes for turbo oil feed lines are -3 or -4 lines.

    -Michael McCoy

+ Reply to Thread


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
1e2 Forum