+ Reply to Thread
Results 1 to 7 of 7
Thread: telescoping steering column
03-28-2005 05:21 AM #1
03-28-2005 09:47 AM #2
- Memphis, TN, Seems obvious.Member No: 38242
Inner Circle ©138 since: Jan 06, 2005
- Join Date
- Jun 2002
- Rep Power
03-28-2005 12:09 PM #3
03-28-2005 12:27 PM #4
03-28-2005 12:28 PM #5
03-28-2005 12:44 PM #6
Re: telescoping steering column
It should move over an inch more like 3-4. Some of the early build date E34's with drivers air bag did not have the adjusting lever. If you have the lever or on the later models the stalk on the steering collum will move or allow at least an amount equal to the above.
If yours does have the lever or the stal (electric), check the large nut at the base of the steering shaft behind the panel and pedals. I bought one at one time that the nut had been tightened too tight and it would not budge until I loosened it. You can also lightly lube that telescoping shaft a bit to make it move easier. It's easier to put a wrench on the nut, put the key in the ignition and turn on (not start) so the steering wheel will turn. Hold the nut with the wrench and turn the steering wheel.
11-07-2010 10:52 PM #7
Re: Me, too
I have a '94 530iT that has the common stuck telescoping steering column. I, too, could only get about 1/2 inch movement and agree there is a lot of gear under there for only 1/2 inch movement. I'm almost ashamed to admit that after loosening the big nut, I squirted penetrating oil, pried, tapped (ok, hammered...) pried some more, all with no appreciable change. THEN (drumroll...) I used heat on the telescoping portion. I didn't want to chance burning the car up with a torch, so used an electric heat gun designed to ease removal of paint. I aimed the heated air at the portion at the nut and just above it for no more than two minutes. VOILA!!! I believe the grease in the splines had hardened and stuck the two pieces together. Now I get complete travel, which is much more than 1/2 inch. I tightened the nut back until I could still adjust the steering wheel, but there was some smooth resistance. I had searched many forums without success, but this process was very quick and successful. Hope it helps anyone else who finds it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)